SMT Splice Tape Application Procedure

    I. To begin the splicing procedure, first remove protective liners from both ends of the Slicing Tape.

    II. Place end of OLD reel over the pins , to make a near seamless joint.

    III.  It is recommended to loosen the cover tape by lifting it with a knife about 1/8-inch (3mm) from beginning of the new reel. Place the carrier tape over the pins using KDW Splice Tool.

    IV.  Place end of OLD reel over the pins, to make a near seamless joint.

    V. Close the Splicing Tool.

    VI.  Place narrow strip of spicing tape over the covers of the joined tape. The narrow splicing tape is for 8mm carrier tape. Use the wider strip of splicing tape for >12mm carriers tape. Extra-long splicing strips are included and are only  necessary To use on very wide carrier tape.

    VII. The Splicing procedure is now completed. Remove the joined carrier tape from the Splicing Tool and feed into the Pick and place machine without line shut-down.

Contact us to learn more about KDW Splice Tapes.

View KDW Splice Tapes at

Http: //www.smtsplicetape.com/smt-splice-tape/

Website: www.smtsplicetape.com

Contact us:  kdw@ai-part.com